Certain cables where colored insulation can't be used or doesn't make sense can use indelible markings at terminations (usually white) or a ridge along the neutral side of the cable (typically seen on flat cords). The neutral (grounded conductor) must be white, gray, some non-green color with three white stripes, or white with some non-green stripe (this isn't listed in the NEC, but is technically allowed as it's how the second neutral in an x/2/2 cable is configured).To summarize what the NEC itself requires on this topic: You should attach the white at the fixture so that in any subsequent wiring project it will already be properly connected. So if you are running a new wire, you might as well use 14/3, use the black and red for the switch and leave the white capped in the switch box.
Xtrafinder shows wrong colors code#
The code required that the white wire be marked black (or red) to show it was hot.Ĭode now requires that all new switches have a neutral, so the old two wire switch loop is not allowed, even if you are using a dumb switch that doesn't need a neutral (some future switch might). On your followup question, it was very common to use 14/2 or 12/2 wire to run a switch loop (a hot line to the switch and a switched hot returning from the switch). I do not specifically know Michigan code (and it probably varies by local jurisdiction), but it almost certainly follows the standard code when it comes to wiring colors. And for someone else working on your circuit, it is essential.Ĭode in all states that I know of in the US require correctly marked wire (either the original jacket or a subsequent marking). That way, when you return to the fixture/switch/outlet three years from now, even if you cannot remember what you did, the color of the wires will guide you.
If it is not bare, white or green, it is potentially hot.Ĭode lets you use wire with a different color insulation than the standard if you mark it permanently with the correct color, such as a piece of colored electrical tape, heat shrink tubing or with paint. The color is meant to inform both you and any future worker which wires are hot (usually black or red, but occasionally other colors, such as blue), neutral (white or sometimes grey), ground (bare, green or green/yellow striped). But electricians (both pros and amateurs) do.
0 kommentar(er)
